Monthly Tech-Tip | No tracking! No ads! |
Available on the Downloads page
This assembly is the bottom half of a 3D printed 0.8mm wall thickness PLA mold. Plaster exerts a lot of pressure, especially in deep molds, even super gluing a disk onto a bottom flange can fail and result in a plaster spill. This is a "belt and suspenders" solution. This disk is thick and strong and it is removable. Paper clamps hold it onto a flange on the sidewall of the mold. These recesses enable placing it flat onto a level table.
Typecodes |
3D printing problems
3D printing for mold making in ceramics requires determination and skill. And a memory for the many problematic techniques. |
---|---|
Glossary |
Mold Shell Flange
|
Buy me a coffee and we can talk