Monthly Tech-Tip from Tony Hansen SignUp No tracking! No ads!

# "BTSB04" Firing Schedule

## Bartlett Slow Bisque Cone 04

Step °C °F Hold Time
1 44°C/hr to 121C  80°F/hr to 250F    2:11
2 111°C/hr to 537C  200°F/hr to 1000F    5:56
3 55°C/hr to 593C  100°F/hr to 1100F    6:56
4 100°C/hr to 913C  180°F/hr to 1676F    10:08
5 44°C/hr to 1052C  80°F/hr to 1926F    13:15
Start temperature assumed: 25°C or 75°F
"Fahrenheit degrees" is not the same as "degrees Fahrenheit". A 100° reading on a Fahrenheit thermometer is equal to a 37° reading on a Celcius thermometer. But "100 Fahrenheit degrees of temperature change" is equivalent "55 Celsius degrees of change". That is an important distinction to understand the above temperature conversions.

## Related Information

### Manually programming a Bartlett V6-CF hobby kiln controller

I document programs in my account at insight-live.com, then print them out and enter them into the controller. This controller can hold six, it calls them Users. The one I last edited is the one that runs when I press "Start". When I press the "Enter Program" button it asks which User: I key in "2" (for my cone 6 lab tests). It asks how many segments: I press Enter to accept the 3 (remember, I am editing the program). After that it asks questions about each step (rows 2, 3, 4): the Ramp "rA" (degrees F/hr), the Temperature to go to (°F) to and the Hold time in minutes (HLdx). In this program I am heating at 300F/hr to 240F and holding 60 minutes, then 400/hr to 2095 and holding zero minutes, then at 108/hr to 2195 and holding 10 minutes. The last step is to set a temperature where an alarm should start sounding (I set 9999 so it will never sound). When complete it reads "Idle". Then I press the "Start" button to begin. If I want to change it I press the "Stop" button. Those ten other buttons? Don't use them, automatic firing is not accurate. One more thing: If it is not responding to "Enter Program" press the Stop button first.